In this video, we will break down what it’s like to set up and use a co2 laser! No matter what laser you purchase the setup should be similar for this size laser. A lot of the smaller lasers come mostly assembled but may need minor adjustments. This Laguna Smartshop MX 100w needed a few things installed before we could get cutting as will most mid/large sized co2 lasers. Then we walk through the basics of Lightburn software to make our first engravings!
We went with the Laguna MX 100w laser based on bed size and the power of the laser. You do not have to buy a 100w laser it will just make cut times go a lot faster and typically they have a larger bed area. Laguna offers several laser sizes to fit your budget and I’ll link to the one we have below.
Laguna MX Smartshop 100w Laser: https://bit.ly/3FkbBS2
Ac infinity fan used for extraction: https://amzn.to/3KaOL3f
Mirror alignment videos”
Instagram: https://instagram.com/twomoosedesign
Main Website: https://twomoosedesign.com
DIY Blog Website: https://plantsandprojects.com
Amazon affiliate store: https://amazon.com/shop/twomoosedesign
Two Moose SVGs and digital downloads – https://twomoosedesign.com/collections/digital-downloads
Current affiliate/discount promo codes:
Isotunes Ear Protection promo code 10% off TWOMOOSE
https://isotunes.com
MAS Epoxy promo code for 10% off: TWOMOOSE
https://masepoxies.com/shop/
Walrus Oil wood oil promo code for 10% off: TWOMOOSE
Wood Care
BAD Workwear promo code 10% off TWOMOOSE10
https://badnorthamerica.com
Free Stocks With Webull! Trading is one of my favorite hobbies!
https://act.webull.com/ni/I1vyli3Q4aUF/5v7/inviteUs/
#lasercutter #lasersetup #LagunaMX
UCwCvuJEBE0DPAncgXl7cybg
laser engraver
#easy #set #CO2 #laser #Engraver #Cutter