“When laser scans the graphics in two-way maybe cause the edge of the scanned graphics uneven due to the relationship between the machine belt tensions. Therefore, increase backlash to correct it. It has the specific backlash for the certain speed. Generally, the faster the speed, the greater the backlash.” (Ref: RD Works User Manual) – […]
This video is about the Machine Origin, Job Origin and Start Location when using Co2 Laser Software. The Laser software I use is Lightburn. Now I know that not everyone uses Lightburn Software so towards the end of the video I will briefly explain where to find these settings in two other Laser Software Packages […]
In this video I show you how to install the Ultimate Air Assist Components from Cloudray Laser on a Co2 Laser using a Ruida RDC-644X Controller. The components for this can be found here https://mwlaser.com.au/product/ultimate-air-assist-kit/ This is an awesome addition to the machine, I have recently purchased a second one for the Laser Machine I […]
This video explains the installation of the Z-Axis Focus Sensor from Cloudray Laser. https://amzn.to/2Jo9m5B .This sensor for the Co2 Laser is used with controllers capable the Auto Focus feature. It can only be installed on a machine that has the work table controlled by the z-axis controls on the laser control panel. In this video […]
In this video I install a mA Meter (ammeter / milliamp meter) on a Co2 Laser. This is a simple process that requires care and knowledge of your system! WARNING (See 0:28) I Recommend a 0-30ma ammeter for Co2 Laser tubes up to 80W – https://mwlaser.com.au/product/cloudray-30-50ma-ammeter/ A LIST OF UPGRADE PARTS I USED CAN BE […]
This Video demonstrates how to adjust the belts on the x and y axis rails on a Chinese Co2 Laser machine. To help with eliminating backlash / off set at the start and finish locations of laser cut shapes. I produce these videos to help you and others with their Co2 Laser machines. If you […]