In this video I go step by step on how to remove the factory air assist in my Omtech laser and install a larger quieter air assist that turns on and off. Supplies used in this video Air Compressor – California Air tools – https://amzn.to/39UXgSi Regulator – https://amzn.to/3N6QM10 Solenoid – https://amzn.to/3L7mM3F Hose and Fittings –...
How to calibrate the stepper motors for X & Y Axis on Trocen AWC708S Controller. Create a square in Laser Software 100x100mm Cut from a piece of material using the cut settings for that material.Now measure the X & Y axis. Follow Directions in Video on how to change the Distance Per Pulse(um) length and...
In this video I show two methods of making a manual pulse button for the Co2 Laser, to enable you to pulse the laser for mirror alignment without needing to pulse from the Laser Control Panel. This allows for quicker alignment and less walking around the laser machine. IMPORTANT: Proper safety precautions should be used...
COMMON PROBLEMS OF CO2 LASER POWER AND TROUBLE SHOOTING CO2 laser machine is widely applied into laser engraving and cutting. It mainly consists of luminous system, motion system and control system. Today, we introduce the judgment and elimination of CO2 laser power problems. 1. Laser head does not emit light when working First situation, check...
Is it worthwhile replacing the Air Pump which was shipped with your Co2 Laser Machine, with an Air Compressor? Will it improve the results from your laser machine? Aren’t Air compressors extremely noisy, I don’t want all that noise in my workshop? To address that last question 1st, no not all air compressors are noisy,...
There are many times when we all experience poor cut quality from our Co2 Laser machines. It may be all running well one day and then the next something has changed and you cannot seem to get a good quality cut. If you are not getting a good quality cut on your machine, this short...
This is a quick guide to selecting the right laser focal length lens for the material you process with your Co2 Laser machine. To find the right focal distance from the laser nozzle to the work surface a ramp test is performed to be able to measure accurately the distance you should set the height...
This Video demonstrates how to adjust the belts on the x and y axis rails on a Chinese Co2 Laser machine. To help with eliminating backlash / off set at the start and finish locations of laser cut shapes. I produce these videos to help you and others with their Co2 Laser machines. If you...
Building your own Co2 Laser can be rewarding and you can avoid large import duties, shipping and taxes that you would pay on a pre-built laser machine & you get to design it how you want it, to your own specifications. More Info and Product Information I Use for This Build Can be found on...