Now all walks of life can see the shadow of laser processing technology, laser cutting machines, laser welding machines and other processing equipment are also increasingly widely used. However, when many customers use the laser cutting machine, they will have a series of problems, such as the wrong direction of the startup reset and the beam shake, because they are not familiar with the laser cutting machine or operate improperly. Today, we have compiled a solution for the above fault causes!
1. Check whether the cross beam deviates seriously. The left and right sides shall not be more than 2MM. Check whether the support wheels on both sides are damaged and whether the push is smooth.
2. Turn on the machine to check which axis the jitter appears on, the trolley or the beam, and disconnect the power supply of one axis to test whether the motor and drive (block) of the other axis are faulty. The test can be interchanged to find out whether the problem lies in the motor or the driver (block).
3. If the reset is abnormal after replacing the laser cutter driver, you should first check whether the parameter setting is correct. By changing the main board parameters, you can solve the problem of abnormal reset.
4. Push the trolley to see if there is friction or shaking. If there is excessive clearance between the sliders, replace the sliders of the laser machine.
5. Turn off the machine and push the trolley and beam by hand to see if there is resistance. If there is any obstruction, remove or tidy it, and check whether the left tensioning wheel is tight.
6. For models equipped with resistance row, the resistance shall be measured. If the resistance is not correct, replace the resistance row.
7. Check whether the synchronous belt, bald head, blowpipe and drag chain are blocked.
8. When the laser cutting machine is reset, the direction is correct, but at the end point, the car or beam cannot stop and hit the machine. Check whether the main board parameters are correct. If the sensor wire is broken or the sensor is damaged, check whether the magnet is in a reasonable position.
9. Check whether there is too much dust on the guide rail of the laser machine that hinders the car. Clean the dust and add lubricating oil to the slider.
10. If the problem still exists, it may be the main board fault, and the laser cutting machine control main board needs to be replaced. Check whether the wire connecting the motor and the driver (block) is in good contact.
The above is the analysis and solution of the laser cutting machine’s abnormal reset, beam shake, startup and wall collision, and other faults. I hope it can help you! As a professional laser cutting machine manufacturer, Xinquanli Laser has created value and benefits for the automobile manufacturing industry, rail transit, engineering machinery, agricultural machinery, elevator manufacturing, grain and food machinery, pharmaceutical machinery, aerospace and military industry, petroleum machinery, metal structure and specialized sheet metal processing and other industries.