The laser cutting machine adopts laser cutting technology, which has greatly improved the working efficiency of the cutting machine, and has higher technical requirements for the operators to avoid injuries in the work. Xinquanli Laser explains what to pay attention to when operating the laser cutting machine.
The safety operation regulations of the laser cutting machine must be strictly observed. Start the laser in strict accordance with the laser startup procedure. The operator must be trained to be familiar with the structure and performance of the equipment and master the relevant knowledge of the operating system. Wear labor protection articles as required, and wear protective glasses that meet the requirements near the laser beam. Do not process a material until it is clear whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam. When the equipment is started, the operator shall not leave the post or entrust others to be in charge without authorization. If it is really necessary to leave, the operator shall stop the machine or cut off the power switch. Keep the fire extinguisher within easy reach.
Turn off the laser or shutter when not processing; Do not place paper, cloth or other inflammables near the unprotected laser beam. If any abnormality is found during the processing, the machine shall be shut down immediately, and the fault shall be eliminated in time or reported to the supervisor. Keep the laser, the bed and the surrounding area clean, orderly and free of oil, and stack the workpieces, plates and waste materials according to regulations. When using gas cylinders, avoid crushing welding wires to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder supervision regulations. Do not expose the cylinder to the sun or close to the heat source. When opening the bottle valve, the operator must stand at the side of the bottle nozzle. Observe high-voltage safety regulations during maintenance. Maintenance shall be carried out according to regulations and procedures every 40 hours or every week, every 1000 hours or every six months.
The above precautions should be paid attention to during the operation of the laser cutting machine. As long as we pay more attention to these details in our daily work, we can ensure our own safety.